Menu Commands » History » Revision 9
« Previous |
| Next »
Hamish, 2018-07-28 21:06
Note that it is currently planned to completely replace the menu system for the next version of wconsd, so these commands will be changing.
This command toggles the state of the binary mode. Binary mode is required for correct use of file transfer protocols, such as xmodem. This mode will be automatically turned on by some telnet clients (if they send the telnet option DO BINARY TRANSMISSION) in which case it may need to be manually turned off using this command.
If the serial port is current open, this command will close it and stop any serial communications.
Print the copyright notice
Sets the number of data bits. This command will not have any affect until the port is closed and re-opened.
Show some quick help for the menu commands
Toggles the state of Telnet keepalives. If keepalives are turned on, then a Telnet Keepalive option is sent approximately once every two seconds. This will create significantly more network traffic than normal, but will help to avoid sessions being terminated unexpectedly
kill_conn Connection ID
Stop a given connection's serial communications. This will close the serial port being used by the given connection ID and thus allow someone else to open that port. This command can be used when an existing session has crashed, or if someone else has logged in and is blocking your work. Since there is no authentication, this command is obviously open to abuse.
open [port number]
Connect or resume communications with a serial port. If no port number is specified then the current default port number is used. If an serial port is already open, this will just resume communication with that port.
Set the serial parity. This command will not have any affect until the port is closed and re-opened.
port port number
Set serial port number. This command will not have any affect until the port is closed and re-opened.
Exit from this session
Show the connections table. This table is mostly used for internal debugging information, however it contains the connection ID for all the current connections, which can be used with the kill_conn command
w000c2989d2df> show_conn_table Flags: A - Active Slot, N - Network active, S - Serial active, M - Run Menu, B - Binary transmission, E - Echo enabled, K - Telnet Keepalives, * - This connection s flags id mThr net netTh serial serialTh netrx nettx peer address - ------- -- ---- ---- ----- ------ -------- ----- ----- ------------ 0 ME 1 1884 55 1598 192.168.1.1:43686 1 ANSMBEK 2 1888 1880 0 1844 1836 68 4264 192.168.1.1:57184 2*AN ME 3 1856 1868 0 109 4657 127.0.0.1:4629 3 0 0 0 0 4 0 0 0 0 5 0 0 0 0 6 0 0 0 0 7 0 0 0 0
- id contains the connection ID for this slot
speed bits per second
Set serial port speed. This command will not have any affect until the port is closed and re-opened.
Show current serial port status
w000c2989d2df> status status: port=1 speed=9600 data=8 parity=0 stop=0 state=open connectionid=1 hostname=w000c2989d2df echo=1 binary=0 keepalive=0
Set number of stop bits. This command will not have any affect until the port is closed and re-opened.
Updated by Hamish over 4 years ago · 9 revisions